Jump to content
David Haddix

2010 MEP Steel placement

Recommended Posts

David Haddix

Has anyone else had problems with placeing steel at the correct elevation in the 2010 MEP with An EastCoast add on?

I am trying to place steel out of the tool palette and when I go into the properties manager I am unable to set a elevation before I place a piece of steel on the drawing.

The dialog box for inputting the elevation will not allow for any information to be entered in before placement .

 

Any Ideas?

Share this post


Link to post
Share on other sites
tzframpton

This is a known issue as far as I'm concerned that is not related to EastCoast design to fab software. I've never been able to right-click and preset the elevation on steel or diffusers. I've even asked about this over the past two versions and some people can, some people can't. I haven't been able to figure it out.

Share this post


Link to post
Share on other sites
David Haddix

Thanks for the info I will let you know if I come up with any solution

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...