robc1985 Posted April 29, 2010 Posted April 29, 2010 I am working on a drawing and it has taken me ages to burst it which has left me with one block. It will not explode at all. I have tried everything. I have made sure that it is says allow exploding. When I click explode it says 'Cannot explode that block.' Ok so I know what to do. I'll go in block editor and copy and paste it all. Wont work! When I click block editor it says 'Enter block name or [?]' I type the block name *E22 and it goes to block editor and shows nothing. It not good! ta Quote
ReMark Posted April 29, 2010 Posted April 29, 2010 Did you try the technique for exploding an anonymous block? Quote
Pablo Ferral Posted April 29, 2010 Posted April 29, 2010 Did you try the technique for exploding an anonymous block? Ooo, What's that?! Quote
ReMark Posted April 29, 2010 Posted April 29, 2010 Pablo: See this thread. If you want the lisp routine go to the post by CarlB. http://www.cadtutor.net/forum/showthread.php?t=45181&highlight=anonymous+block Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.