AutoNewbie Posted August 4, 2010 Posted August 4, 2010 I'm working on a drawing and I've run into some blocks that act like none I've noticed before. This is not a visibility state like a dynamic bock, but this draw has blocks in it that liook like only portions are visible. If you click on one of the apartments and explode it, the entire floor becomes visible. Open it in block editor and the whole thing is there. I can't seem to fathom how only those few apts show up in the dwg... Quote
qball Posted August 4, 2010 Posted August 4, 2010 It might be clipped. XCLIP command. OFF (On, or new, etc....) Quote
AutoNewbie Posted August 5, 2010 Author Posted August 5, 2010 That was it! Thank you very much! That will come in very handy! Quote
suksuk Posted February 8, 2017 Posted February 8, 2017 It might be clipped. XCLIP command. OFF (On, or new, etc....) that is soooooo amazing tecnique mister Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.