gulluwing Posted September 6, 2010 Share Posted September 6, 2010 I have to match the vertices A and C without changing the extent of the lines AB and CD keeping B and D as the rotating pins. Can you help me? " thank's Quote Link to comment Share on other sites More sharing options...
Tiger Posted September 6, 2010 Share Posted September 6, 2010 command ROTATE and use the Parallell OSnap? or Do a XLine from B to A. Move that XLine to D and move C to end up on the XLine Quote Link to comment Share on other sites More sharing options...
gulluwing Posted September 6, 2010 Author Share Posted September 6, 2010 excuse me but I did not understand command ROTATE and use the Parallell OSnap? or Do a XLine from B to A. Move that XLine to D and move C to end up on the XLine Quote Link to comment Share on other sites More sharing options...
eldon Posted September 6, 2010 Share Posted September 6, 2010 Another attempt at interpreting your request. Draw a circle centre B with radius to A. Draw another circle centre D with radius to C. Where they intersect gives the point where A and C should be. Hopefully this is what you require. If not then someone else can have a go. Quote Link to comment Share on other sites More sharing options...
gulluwing Posted September 6, 2010 Author Share Posted September 6, 2010 wonderful,you are great, is what I was looking. thank's Another attempt at interpreting your request. Draw a circle centre B with radius to A. Draw another circle centre D with radius to C. Where they intersect gives the point where A and C should be. Hopefully this is what you require. If not then someone else can have a go. Quote Link to comment Share on other sites More sharing options...
Tiger Posted September 6, 2010 Share Posted September 6, 2010 excuse me but I did not understand I misinterpreted your question, please ignore previous post. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.