Guest NUBBZ143 Posted December 8, 2010 Share Posted December 8, 2010 I have a dynamic block with two linear stretch actions. I can change the linear dim's through the properties but I can't select the stretch grip and drag. Tried placing the block in a new drawing, no change. Any suggestions? Section Label Block.dwg Quote Link to comment Share on other sites More sharing options...
Grant Posted December 8, 2010 Share Posted December 8, 2010 I opened up your drawing and was able to move the lines with the arrows???? - Using Autocad 2011 Quote Link to comment Share on other sites More sharing options...
irneb Posted December 9, 2010 Share Posted December 9, 2010 Your block is also annotative. The block is set to 1:16, but the CAnnoScale is 1:1. Change the CAnnoScale (the pop-up at bottom-right of status bar) to 1:16 as well. You should then be able to grip edit the DB parameters. For some reason 2008 doesn't allow grip edits to DB's when the 2 scales don't match. I think that's fixed in newer acads (like Grant's shown). Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.