Jump to content
Guest NUBBZ143

Can't select dynamic grip

Recommended Posts

Guest NUBBZ143

I have a dynamic block with two linear stretch actions. I can change the linear dim's through the properties but I can't select the stretch grip and drag. Tried placing the block in a new drawing, no change. Any suggestions?

Section Label Block.dwg

Share this post


Link to post
Share on other sites
Grant

I opened up your drawing and was able to move the lines with the arrows???? - Using Autocad 2011

Share this post


Link to post
Share on other sites
irneb

Your block is also annotative. The block is set to 1:16, but the CAnnoScale is 1:1. Change the CAnnoScale (the pop-up at bottom-right of status bar) to 1:16 as well. You should then be able to grip edit the DB parameters.

 

For some reason 2008 doesn't allow grip edits to DB's when the 2 scales don't match. I think that's fixed in newer acads (like Grant's shown).

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...