taiwanchu Posted July 15, 2011 Share Posted July 15, 2011 I have a drawing with an xref clipped several times and laid out but now cannot select them. I have run an audit, recover, purge to all xrefs and the parent file. The xref had some errors so I wblocked the whole drawing out and replaced it which at first helped but then the parent file still had the same problems. Some text in the parent file is not selectable either until a full reboot of Acad. Any suggestions? Quote Link to comment Share on other sites More sharing options...
DANIEL Posted July 15, 2011 Share Posted July 15, 2011 check to make sure it hasnt locked your xref layer Quote Link to comment Share on other sites More sharing options...
taiwanchu Posted July 15, 2011 Author Share Posted July 15, 2011 Not locked. not on layer 0. not on defpoints. Quote Link to comment Share on other sites More sharing options...
DANIEL Posted July 15, 2011 Share Posted July 15, 2011 have you tried temperarily turning of the clipping boundry? Quote Link to comment Share on other sites More sharing options...
taiwanchu Posted July 15, 2011 Author Share Posted July 15, 2011 boundary off, on, 0, 1 or 2 doesn't matter. Quote Link to comment Share on other sites More sharing options...
DANIEL Posted July 15, 2011 Share Posted July 15, 2011 you may need to post the file for someone around here to take a look at, I personally don't have time currently but i'm sure someone else around here will be willing to take a look at it for you. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.