rengised Posted October 12, 2008 Share Posted October 12, 2008 Hello guys, how to extend an arc in accurate length from end point or it is possible to make a new arc from end point as well? appreciate your help see attached below the sample arc drawing Arc.dwg Quote Link to comment Share on other sites More sharing options...
eldon Posted October 12, 2008 Share Posted October 12, 2008 Have you tried the command Lengthen? Quote Link to comment Share on other sites More sharing options...
rengised Posted October 13, 2008 Author Share Posted October 13, 2008 I tried it now buddy, but i dont know how to do it i want to extend the arc 1n 1000mm exactly Thanks again Quote Link to comment Share on other sites More sharing options...
rengised Posted October 13, 2008 Author Share Posted October 13, 2008 Now its ok Eldon Thanks for your help Quote Link to comment Share on other sites More sharing options...
papagyi Posted October 13, 2008 Share Posted October 13, 2008 I did extend and lengthen methods for arc and wrote some tips.Pls check it. Arc.dwg Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.