Jump to content

AutoDesk Seek Design Content

clipper392

By clipper392
in AutoCAD Beginners' Area

 Share

Recommended Posts

clipper392 Explorer

clipper392

Posted
Posted

I have been looking at the Design Content function in AutoCAD 2012 and was wondering why if the content to be inserted says it is bolt side profile 10mm x 50mm. Why it doesn't come in at those dimensions when scale factor of 1 is set. It is't until I use a Scale Factor of 1.0162 that the profile comes in at the correct scale.

Thanks for any suggestions.

ReMark Grand Master

ReMark

Posted
Posted

Could it be that you are inserting a metric bolt into a drawing set up to use imperial units?

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing
×
×
  • Create New...