Jump to content

Manual Junction Design

278 Consulting

Recommended Posts

I'm trying to design a junction without using the Wizard. I can generate all of the necessary baselines/regions and target the Curb Return assemblies to a Feature Line generated along the carriageway edge of the Primary Road. What I can't work out is how to vertically attach the Curb Return kerbline profiles to the Primary Road corridor such that if and when I redesign the Primary road, the Curb Return kerblines dynamically update their level too.

Link to comment
Share on other sites

Civil 3D does not have dynamically linked profiles (Only to surfaces, not each other). There are some very complicated work arounds that you may be able to use, but they take a long time to set up.


Another option would be 3rd party software for that.

Link to comment
Share on other sites

Bill, Thanks for the response. I think I guessed as much but was hoping that someone may have found a clever way around it. Oh well, back to doing it manually and redesigning the Curb Returns everytime I change the mainline profile

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...