Sewer Linetype with size, type, and flow

[Bakuku]

Hello,

 

I use C3D 2011, and for the life of me I can't get it to work. I created the LT by using the Express tools>Tools>Make Linetype. I went through the procedures and here's the code:

 

*8ACPSEWER,8ACP_Sewer
A,1.544489,[">",ROMANS,y=-.426442,s=1,u=0],3.602006,-.376281,["S",ROMANS,y=-.551197,s=1,u=0],-1.689956,1.544489,[">",ROMANS,y=-.426442,s=1,u=0],3.602006,-.769301,["8''ACP",ROMANS,y=-.602394,s=1,u=0],-5.675395

I know about the single quotes that's right after the 8 on 8''ACP. For some reason the LT spacing is all whacked. I can change that with the spacing, but what's not showing are the ">" with the LT. I have another LT that shows a flow line and it works fine.

 

Much appreciated if anyone can help me.

[SLW210]

Try to see if it will work with STANDARD instead of ROMANS.

 

I got a bad definition at line 640 when I tried to load it.

[Bakuku]

Try to see if it will work with STANDARD instead of ROMANS.

 

I got a bad definition at line 640 when I tried to load it.

 

 

Thanks for the reply.

 

I changed it, and I am still getting the samething. hrm....

[SLW210]

Could you post an image of the linetype you are trying to make? Maybe there is a better way to make it.

 

Do you get any messages?

[Bakuku]

Hello again,

 

I don't get any messages. Here's a screen shot.

 

Sewer.pdf

 

Sorry had to trim it because the file was too big...