nredington Posted March 15, 2013 Share Posted March 15, 2013 I was wondering if there is a quick and easy way to fix shaky lines in a drawing? I had to draw with angles that make the lines look terrible. Just didn't know if there was a shortcut command I could use to make them look better? Otherwise I will have to redraw. Thank you! Quote Link to comment Share on other sites More sharing options...
ReMark Posted March 15, 2013 Share Posted March 15, 2013 Angled lines will appear to have a case of the jaggies. I wouldn't be too concerned with it. There is no need to redraw any of your geometry. Quote Link to comment Share on other sites More sharing options...
nredington Posted March 15, 2013 Author Share Posted March 15, 2013 Thanks for the reassurance When I plot to a PDF the lines really don't look too bad! When drawings angles for buildings sometimes it's just not right... Quote Link to comment Share on other sites More sharing options...
ReMark Posted March 15, 2013 Share Posted March 15, 2013 When the lines begin plotting as bad or worse than they appear on your screen that's the time to start worrying. Quote Link to comment Share on other sites More sharing options...
cadvision Posted March 21, 2013 Share Posted March 21, 2013 check what DPI you are plotting to PDF in? Low res PDF will look pixely Quote Link to comment Share on other sites More sharing options...
koog Posted July 12, 2013 Share Posted July 12, 2013 Make sure viewres is set to 10,000. Quote Link to comment Share on other sites More sharing options...
ReMark Posted July 12, 2013 Share Posted July 12, 2013 A Viewres setting of 5000 is more than sufficient in most cases. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.