average_male Posted December 5, 2008 Posted December 5, 2008 Hello Everyone, Is there such a function that will "resample" or "reduce" the number of points that make up an arc or curved line? I have a drawing that consists of many curved lines, with many curves containing something like 20 data-points. These types of curves can easly be represented with say 4, or 5 data points. I could use the 3 point-arc/spline command and reconstruct the curves/ars but given the number of curves, it would take very long. Thanks for any tips you can provide, Joe Quote
CarlB Posted December 5, 2008 Posted December 5, 2008 I checked similar threds that shows up at bottom of page. A weeding routine posted at http://www.cadtutor.net/forum/showthread.php?t=17067 and http://www.cadtutor.net/forum/showthread.php?t=25098 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.