RONK79 Posted September 10, 2014 Posted September 10, 2014 this is for a friend at a different company, her company prohibits these forums at work... in the drawing, a dumb valve was used in the smart drawing as a simple block and now it attached itself to the line its connected to and can not be erased without erasing all the connected components. any ideas how it got attached, or how to un attached it with out deleting and starting over... Quote
ReMark Posted September 10, 2014 Posted September 10, 2014 In Electrical there is a Delete Component command that would remove the block and reconstitute the line. Is there no such similar command in P&ID? Quote
RONK79 Posted September 10, 2014 Author Posted September 10, 2014 not sure, will have to give it a try... thanks ReMark! Quote
Jach Posted September 12, 2014 Posted September 12, 2014 hi RONK79 do you still have this problem? Quote
ReMark Posted September 12, 2014 Posted September 12, 2014 Let's assume he does. What advice do you have to offer Jach? Always good to have a backup plan. Quote
RONK79 Posted September 12, 2014 Author Posted September 12, 2014 The problem still exists, been trying to work around it by heavy usage of dynamite...lol. Quote
ReMark Posted September 12, 2014 Posted September 12, 2014 Can't your friend create a custom "smart" valve (block) in P&ID and substitute it for the "dumb" valve block? Quote
Jach Posted September 22, 2014 Posted September 22, 2014 ah sorry, i was send to spain for week at my company so didnt get time look further into this. this dumb valve, is it block made outside of AutoCAD P&ID? what i mean by this is it a dynamic block create in a other version of AutoCAD P&ID? Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.