SAM_R Posted July 22, 2015 Share Posted July 22, 2015 When I publish a drawing(s) to PDF the whole thing shifts up and to the right, but when I PDF normally it comes out fine.B.pdf I have attached the PDFs. What could be causing this? A.pdf Quote Link to comment Share on other sites More sharing options...
RobDraw Posted July 22, 2015 Share Posted July 22, 2015 It's usually due to different page set-ups. Quote Link to comment Share on other sites More sharing options...
BIGAL Posted July 23, 2015 Share Posted July 23, 2015 I had this problem ended up turning dwg upside down to get to work it, would just shift it no idea why and not every dwg. Plotting a set of std dwgs for a manual very simple single page in each dwg. Quote Link to comment Share on other sites More sharing options...
MonkeyTurnip Posted July 23, 2015 Share Posted July 23, 2015 when you are plotting normally to PDF what PDF software are you using? when you use publish to PDF, as default it will use DWG to PDF, and will use the settings in that. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.