Jump to content

XPIPE/XTUBE Not Showing Up in Particular File and Feature Lines


darkman257

Recommended Posts

Hello -

 

New here and new to lisps. One Question: (second question was answered on another thread)

 

I found the xpipe and xtube lisp from another thread and it works but it has stopped working in one particular file. If I open a vanilla drawing, draw a pline, and do xpipe/xtube it works just fine. In the file I am working on however it does not want to work anymore. I have exited and reopened and reloaded the lisps. All I get in 2-d is a circle on one end of the pline. I have done audit and -purge and that still did not work. Any thoughts?

Edited by darkman257
Link to comment
Share on other sites

This is not necessarily a bump but I tried this on another computer and the results are the same in regards to xpipe and xtube only displaying a circle on the x,y plane at the end of the poly line and not going along the extruded path. Is there a system variable that I might have changed for this particular file?

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...