halam Posted April 14, 2017 Share Posted April 14, 2017 (edited) I'm now working in a dwg file in which some polylines act very strange. Ca't seem to snap on any points on them and they are slowing things down quite rapidly. These yellow ones where inside a 2018 array i think , but hey, .. it's supose to be backward compatible anyway, right.. Wanting to trim these polylines (blue lines). The red polylines act normal, where the yellow ones take ages to be trimmed. I have no clue. strange case proxy polylines.dwg Edited April 14, 2017 by halam Quote Link to comment Share on other sites More sharing options...
ReMark Posted April 14, 2017 Share Posted April 14, 2017 Have you looked at the drawing in an isometric view? What may appear as a single polyline in a top view is really a series of polylines closely spaced one under the other vertically. Same goes for the some, but not all of the red polylines. Quote Link to comment Share on other sites More sharing options...
halam Posted April 16, 2017 Author Share Posted April 16, 2017 Good catch ReMark! somehow along the way i lost control over the array.. controls for path and display switching of array is so slow i cannot follow and abort. AutoCAD is getting 'fat' & getting slow imo.. Same handling with BricsCAD v15, done instantly! Quote Link to comment Share on other sites More sharing options...
BIGAL Posted April 17, 2017 Share Posted April 17, 2017 getting 'fat' & getting slow Its like 15 years ago now and met with some Autodesk reps showing how good CIV3D was, they showed grading and it was a bit of a wow till we asked the question do a cut=fill and there answer was just repeat till volumes are acceptable my answer was our other software has done this previously for the last 15 years, so we are at 30 years now and is it there ? Quote Link to comment Share on other sites More sharing options...
halam Posted April 17, 2017 Author Share Posted April 17, 2017 (edited) I think the glow effect is the cause of the delay. Probably no 'skip it' being coded if more than xx items selected at once. What setvar can turns off, .. If.. (reactor?) *EDIT is there any to turn of preview behaviour? Google and Autodesk can't help me out (?) .. https://forums.autodesk.com/t5/autocad-lt-forum/preview-effect/td-p/1485061 Edited April 17, 2017 by halam Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.