PJ01 10 Posted October 4, 2017 Hello, as a raw newbie, I have made a 100 x 200mm rectangle on my Model tab, and on the Layout tab, have prepared an A4 sheet, with border and Vport and Title block. However, the drawing does not show up on my Layout Can anyone please advise any steps I may have missed? Share this post Link to post Share on other sites
ReMark 30 Posted October 4, 2017 Did you activate the layout viewport then do a zoom > all or zoom > extents? Share this post Link to post Share on other sites
Dadgad 11 Posted October 4, 2017 (edited) Welcome to CADTutor PJ01. Double click into your Viewport, then Zoom Extents. Whoops, ReMark to the rescue. Edited October 5, 2017 by Dadgad Share this post Link to post Share on other sites
PJ01 10 Posted October 4, 2017 Thank you, this worked perfectly. And the 1:1 print out measured exactly 200 x 100 Share this post Link to post Share on other sites