Removing lines on pipe fittings

[Siberian]

Where I'm from elbows and tees in a pipe run are typically displayed without the lines at each connection shown in the picture so that an elbow would only look like an arc. I know I can edit the family files and remove them, but that is a somewhat tedious task. Is there any simpler way of achieving this?

 

[tzframpton]

It's not that tedious. I removed the lines 8 years ago. Doing it once, it's done for good. I also took out the arc... mitered all the way. Our single line piping plans look great.

 

-TZ