Jump to content
Sign in to follow this  
The AutoCAD Blog

Map 3D Toolset Tools for Regular AutoCAD Objects [Part Three]: Transform and Rubber Sheet

Recommended Posts

The AutoCAD Blog
Rubber Sheet

In our last installment of the series on time-saving Map 3D toolset tools, we will explore Transform and Rubber Sheet.

Transforming and Rubber Sheeting

Both the Transform and the Rubber Sheet tools in the Map 3D toolset allow you to adjust drawing objects based on other objects or points in the drawing. The Transform tool permanently scales, moves, and rotates objects within the current drawing. The Rubber Sheet tool extends the Transform tool by performing non-uniform (skewed) adjustment based on control points in the drawing. Both tools have no direct equivalent in AutoCAD.

Let’s look at an example of using these tools. In the drawing below, I have data that was located in the field by surveyors with no coordinate system defined, and it needs to be transformed to the correct spot. We also have some data that needs to “fit” (rubber sheet) into an existing parcel (someone accidentally brought it in the wrong units).

Rubber Sheet AutoCAD

The Transform Tool

The transform tool is located in the Ribbon: Tools tab > Map Edit panel > Transform tool. The basic workflow of this tool is the following:

1. Select the appropriate objects.

Select Objects Transform tool AutoCAD Map 3D toolset

2. At the First source point prompt, snap to the first source point.

Snap AutoCAD Transform Map 3D toolset

3. At the First destination point prompt, snap to the destination point.

Snap AutoCAD Transform Map 3D toolset

4. At the Second source point prompt, snap to the second source point.

Snap AutoCAD Transform Map 3D toolset

5. At the Second destination point prompt, snap to the second destination point.

Snap AutoCAD Transform Map 3D toolset

The objects are automatically transformed.

Snap AutoCAD Transform Map 3D toolset

I think I hear oooooohs and aaaaaaahs right now.

The Rubber Sheet Tool

The Rubber Sheet tool is located in the Ribbon: Tools tab > Map Edit panel > Rubber Sheet tool. The basic workflow of this tool is the following:

1. Navigate to the Ribbon: Tools tab > Map Edit panel > Rubber Sheet tool.

2. At the Base point 1 prompt, snap to the first base point.

Snap Rubber Sheet Map 3D toolset AutoCAD

3. At the Reference Point 1 prompt, snap to reference point 1.

4. Then, you repeat this process for as many points you need to rubber sheet the objects into the area of interest. In this case, it’s the other three points of the rectangle.

5. At the last Base Point prompt, press ENTER.

6. Select the objects, and press ENTER.

7. The objects are rubber sheeted into the rectangle.

Snap Rubber Sheet Map 3D toolset AutoCAD

And there you have it!

Be sure to check out our entire “Map 3D Toolset Tools for Regular AutoCAD Objects” series. These are just some of the awesome Map 3D toolset tools that truly save you hours of time editing regular AutoCAD objects.

The post Map 3D Toolset Tools for Regular AutoCAD Objects [Part Three]: Transform and Rubber Sheet appeared first on AutoCAD Blog.

afmVajOvq78

View the full article

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...