MeGuinness Posted Tuesday at 05:28 PM Posted Tuesday at 05:28 PM hi guys , is there a way to offset text ? i created the letters and then used the extruder command...cut..so to have the letters embossed to a surface, now i need to create the same letters but 4 mm thick that need to be snapped in on the surface embossed slots, i need to reduce the size slightly so the fit in the slots ...im able to offset anything that i created using LINES or Circle but not the letters . any help appreciated. thanx Quote
BIGAL Posted Tuesday at 11:53 PM Posted Tuesday at 11:53 PM Use Seants text to geom. or TXTEXP a built in explode text. TXTEXP Arial bold with a Oblique of 10. Then pedit multi, then extrude. Text 2 geom.zip Quote
MeGuinness Posted yesterday at 01:05 AM Author Posted yesterday at 01:05 AM 1 hour ago, BIGAL said: Use Seants text to geom. or TXTEXP a built in explode text. TXTEXP Arial bold with a Oblique of 10. Then pedit multi, then extrude. Text 2 geom.zip 99.75 kB · 50 downloads thanx for your reply, I'm new to inventor... learning , can you explain what to do with the file you shared please. thanx again Quote
BIGAL Posted 1 hour ago Posted 1 hour ago (edited) What I posted is for Acad, Bricscad etc. Not sure if Inventor has a TXTEXP, some one will comment. Edited 1 hour ago by BIGAL Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.