Penn Foster Structural Project

[LJade]

Ive been looking for references to the Structural Project and found this website. It has helped but I worry alot of the instructions have been updated from the previous post. I'm stuck on the section Drafting Details C, C1, and C2. I feel like I'm missing something and was wondering if anyone could give me some guidance. (I am completely new to Drafting & AutoCAD.) I have uploaded the instructions and my progress via this sheet. Thanks!

reading_assignment_core_1.html

[ReMark]

The above is somewhat difficult to read/understand but I will do my best.  Let's start on the left.  The rebar should not extend through the bottom of the footing.  The concrete slab (ground floor) appears to be missing.  I don't see the steel decking in the floor above and the roof.  Your depiction of the vertical steel cladding is incorrect.  As regards Detail C1: the flashing should also extend down the exterior face of the structure, and both ends of the flashing should have an angled drip edge.  And your steel column is missing the lines denoting the flange.  As regards Detail C2: Lines denoting flange on column are missing.  Steel decking is missing.  Beam that attaches to column is missing.  Angle and bolt appear to be sized incorrectly.  Steel cladding shown correctly.  It looks like you have the concrete roof slab sitting inside the channel when in fact the slab, along with the steel decking and rebar would all sit atop the channel.  I'm positive there is more I could comment on but that's the best I can do at the moment.  There are several threads in this particular forum that deal with the Penn-Foster structural assignment where these very same details show up.  Have you looked at any of them?