Viewports in LT2008

Is there any way you can draw an irregular shped viewport in LT2008 (i.e. not a rectanlge)????

Cheers:oops:

I'm not sure of the limitations of LT but if when you enter the MVIEW command you don't have options for Object or Polygonal then I think you're out of luck.

That's what I suspected.

Cheers anyway:):)

I'm not sure of the limitations of LT but if when you enter the MVIEW command you don't have options for Object or Polygonal then I think you're out of luck.

AutoCAD LT 2008 actually has these options. Just type MVIEW to invoke the command.

AutoCAD LT 2008 actually has these options. Just type MVIEW to invoke the command.

When I type MVIEW, the options I get are: ON/OFF/Fit/Shadeplot/Lock/Restore/LAyer/2/3/4

And this is AutoCAD LT 2008? Because we have 6 seats of LT 2008 and I just went to our other station and checked before I posted.

And this is AutoCAD LT 2008? Because we have 6 seats of LT 2008 and I just went to our other station and checked before I posted.

It certainly is.:(

i thought this was a new addition to 2009, but i cannot be sure.

it was (link http://lynn.blogs.com/lynn_allens_blog/2008/04/more-autocad-20.html )

When I type MVIEW, the options I get are: ON/OFF/Fit/Shadeplot/Lock/Restore/LAyer/2/3/4

yes, it is same in my LT2008 as well.

You can however use wipeouts to "shape" the viewport though... not a solution but a possible workaround... if wipeouts are available in LT?

Is this possible in LT 2008?