osx311 Posted August 29, 2008 Posted August 29, 2008 on a 3d car project i am working on i drew up the outline then extruded it based on that i traced over everything and deleted the extrusion marks now as i try and add gradient and hatch it never turns out right how can i do this??? Quote
osx311 Posted September 2, 2008 Author Posted September 2, 2008 i know it isnt to complicated or nice looking but its what i have... its like i cant put a color to a face cause they are all lines CAR2.0.dwg Quote
f700es Posted September 2, 2008 Posted September 2, 2008 use the "3dface" command and follow the point (corners) around your side window and see if this helps. Good luck and welcome aboard Quote
osx311 Posted September 2, 2008 Author Posted September 2, 2008 any hints on curves 3dface is amazing hah Quote
f700es Posted September 2, 2008 Posted September 2, 2008 any hints on curves 3dface is amazing hah There used to be some nice 3D face commands in ACAD but solids might be a better choice these days. I added two faces to your car for you to see. These were easy since they were flat and not curved. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.