Lines at same angles but not parallel?

Hi guys!

Just wondered if anyone can answer this,

I have 2 lines on AutoCAD LT 2009 both of which I've drawn at 32degrees. Now, hoping they would be parallel i continued my drawing only to find later that they're a differenct distance apart at 1 end compared to the other?

Just wondered if anyone had come accross this before? And why it does it? (is it drawing it possibly just a couple of seconds out?)

I've attached the lines on a .dwg as an example, hopefully someone can figure it out!

Thanks in advance!

angle example.dwg

Try changing the precision of your Angle Units; then you will notice that the yellow line is not at 32 degrees

ah! damn, on the original drawing i took it from the majority of my lines follow the same angle as the yellow 1, but the grey 1 is the 1 i needed them to follow!

ok thanks! figured 1 might be out!

any chance you could just remind me how to change the precision of the units?

it's ok! found it again! Thanks for the help NBC!!