Scoobydoo Posted November 4, 2009 Posted November 4, 2009 I have an assembly that calls for a 10' copper ground rod. Is there a way to show a "break line" in it so that the entire 10' ground rod length does not show up? Quote
Scoobydoo Posted November 4, 2009 Author Posted November 4, 2009 I was able to do this when I created a drawing from the assembly. Am I able to do this from the assembly level? Quote
shift1313 Posted November 5, 2009 Posted November 5, 2009 i dont know if there is or not, but you can create a split line on the surface of your ground rod and change the material on part of it to something else, like glass. You could also have two ground rods, one short and one 10' and just change them from visible to hidden. Hopefully someone will have the right answer for you. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.