qball Posted September 1, 2010 Share Posted September 1, 2010 I have Plywood Web Joists and I need to lower them 3" from the Upper Floor Plane. But as you can see on the attached, the z-Direction offset Value is not an option. How come? It is for my steel beams. Quote Link to comment Share on other sites More sharing options...
Dana W Posted September 1, 2010 Share Posted September 1, 2010 Because that object (block) has a specific height, maybe? Quote Link to comment Share on other sites More sharing options...
qball Posted September 2, 2010 Author Share Posted September 2, 2010 oh, Z-direction Justification has to be "other" Quote Link to comment Share on other sites More sharing options...
Jscott85 Posted September 7, 2010 Share Posted September 7, 2010 You can make the start level offset -3 (negative three) and the End Level Offset the same, that will lower the joist 3" Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.