Jump to content

Recommended Posts

Posted

The image below is an unrolled surface of a hexagon tube. Why do the sides overlap? I don't mind if they overlap a little bit, but sometimes it can be pretty bad and obvious.. How do I avoid this? Thank you!

 

untitled.jpg

Posted

Can you zip and attach the original file rather than a picture?

Posted
Can you zip and attach the original file rather than a picture?

 

 

There you go..

untitled.jpg

Posted

You attached the image again, not the file.

Posted

Some of your surfaces have a twist to them so, even though they are ruled surfaces, they are not necessarily developable.

 

If you relax the tolerance setting (Tools-Options-Document Properties-Units) to 0.2 millimeters the edges match up and the resulting area is still very close to the original.

_LowTol.zip

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...