"Pipe Run" Tutorial ???

We just upgraded to 2013, and we now have "Tube & Pipe".

I ran "Pipe Run" a few times to familiarize myself with it.

But it would sure help if I could go through a tutorial.

Does anyone know whether anyone has posted a tutorial for "Pipe Run"?

********Disregard********

Thanks to JD Mather, I was able to locate a tutorial.

If anyone is interested in the tutorial, it can be found here ...

http://wikihelp.autodesk.com/Inventor/enu/2013/Help/0126-Tutorial126/1042-Tube_and1042/1043-Get_Star1043/1046-Create_a1046

I am reading the "Pipe Run"tutorial, and now have a question ...

I am at the section that says -

Create segments using precise dimension values.

The next part says-

"... Right-click in the graphics window and verify that Auto-Dimension is enabled ..."

but when I right-click in the graphics window, I don't see where I would verify that the Auto-Dimension is enabled.

BTW, the tutorial appears to be from Inventor 2009 or before. We are using Inventor 2013.

... The next part says-

"... Right-click in the graphics window and verify that Auto-Dimension is enabled ..."

 

but when I right-click in the graphics window, I don't see where I would verify that the Auto-Dimension is enabled ...

********Disregard********

I figured it out.

You DO right-click in the graphics window, BUT your mouse has to be ON ONE OF THE PROJECTED LINES.