andar424 Posted February 21, 2014 Posted February 21, 2014 How do I properly edit a previously published part? I have a profile of aluminum extrusion that I have been using in frame generator, and just recently noticed that one of the dimensions is off. It is supposed to be 40mm x 80mm, but the 40 is reading 40.054, so it is throwing some of my things off in the assembly. I tried opening another version of it (40x80 lite version because the dims are correct) and doing a save as over the regular 40x80, but that didn't seem to work? Do I need to use the content center editor? I have opened it, and found the part, but don't know how to actually open it up to edit it. Any ideas? TIA! Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.