Jump to content
andar424

Editing a published part

Recommended Posts

andar424

How do I properly edit a previously published part? I have a profile of aluminum extrusion that I have been using in frame generator, and just recently noticed that one of the dimensions is off. It is supposed to be 40mm x 80mm, but the 40 is reading 40.054, so it is throwing some of my things off in the assembly. I tried opening another version of it (40x80 lite version because the dims are correct) and doing a save as over the regular 40x80, but that didn't seem to work? Do I need to use the content center editor? I have opened it, and found the part, but don't know how to actually open it up to edit it.

 

Any ideas?

 

TIA!

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×