Search the Community
Showing results for tags 'pasting'.
I have two surfaces. An EG Surf and a Surveyed Surf. I need to splice the surveyed surf into the EG. The EG is much bigger than the Survey and etirely covers the survey surf. I want the two surfaces to tie in/splice together smoothly. So I thought I would add a 20' or 50' buffer around the survey surf between it and the EG where the two surfaces could gradually tie together instead of sharp changes to connect them. To do this I offset the survey surf border by 50' as a polyline and use that as a hide boundary for the EG surf. Then pasted both into a new blank surface. But instead of tying together in the new surface there is just a 50' gap/hole in between them. Any thoughts?