Glen Smith Posted March 5, 2010 Posted March 5, 2010 Sorry, my bad, I discovered yesterday that an ellipse can not be part of a polyline. They can still be revolved independently. I did a step by step of a horizontal tank with elliptical ends, I'm certain there are other ways to do it, but this uses pretty basic commands. I think you already have the basics, but maybe it will help someone else. Glen 3d tank.dwg Quote
JD Mather Posted March 5, 2010 Posted March 5, 2010 I discovered yesterday that an ellipse can not be part of a polyline. Pellipse Enter F1 Quote
scottalansnow Posted May 15, 2015 Posted May 15, 2015 What other command can you use to create 3D head? Quote
ReMark Posted May 15, 2015 Posted May 15, 2015 (edited) What other command can you use to create 3D head? Well there is a lisp routine posted around here somewhere that would do it for you. I'm sure if you sure if you searched on the word "elliptical" you would find the thread. Never mind. I went and found it for you. Click on this link. http://www.cadtutor.net/forum/showthread.php?47451-Pressure-Vessel-Dished-Head-Lisp&highlight=elliptical Edited May 15, 2015 by ReMark Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.