bigmaz Posted June 1, 2011 Posted June 1, 2011 Hi guys OK, I am trying to create a corridor so I can see the cut/fill slopes on plan. I have set the alignment, created profile with a centerline guide, and created an assembly with 2.00% 2.5m wide LaneOutsideSuper. The tutorial does not say what subassembly to select for the cut/fill. What should I use for this? Thanks Martin Quote
CyberAngel Posted June 2, 2011 Posted June 2, 2011 It depends on the constraints on your shoulders. Do you have to stop at a right of way, i.e. is there a maximum width? Is there a minimum width? Is there a ditch or swale? You may want one of the Daylight subassemblies. Quote
JerryG Posted August 1, 2011 Posted August 1, 2011 Best one to use is the "BasicsideSlopeCutDitch" assembly. It will give you both. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.