K7RDB Posted September 3, 2011 Share Posted September 3, 2011 This used to work, then my computer dies and AutoCad was reinstalled. I am trying to dimension some cut-outs in a 19" rack panel. I can dimension them, it shows the correct dimensions but then when I hit enter it wont save the dimensions. I've gone into DIMSTYLE and everything looks fine but I cant get this simple task to work. Any help would be much appreciated. Quote Link to comment Share on other sites More sharing options...
nestly Posted September 3, 2011 Share Posted September 3, 2011 Try left clicking, instead of Quote Link to comment Share on other sites More sharing options...
acadesign09 Posted September 3, 2011 Share Posted September 3, 2011 I think you need to check the DIMENSION SETTINGS, it may help you to solve your problem. Quote Link to comment Share on other sites More sharing options...
JD Mather Posted September 3, 2011 Share Posted September 3, 2011 Attach the dwg here. Quote Link to comment Share on other sites More sharing options...
SLW210 Posted September 8, 2011 Share Posted September 8, 2011 Make sure the layer is not off or frozen. Quote Link to comment Share on other sites More sharing options...
Arizona Posted September 8, 2011 Share Posted September 8, 2011 ".....then when I hit enter it wont save the dimensions...." As Nestly stated, you need to Pick a point (left click) for the dimension to be Placed. That finishes the command. If you hit enter, you are prematurly exiting the command. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.