Rubbersnow Posted January 16, 2013 Share Posted January 16, 2013 hey guys, I have little problem. I'm trying to draw ventilation in 3D ,and I have reached a point where two air ducts with different sizes must connect to each other,so basically I need to draw a reduction from 1000/200mm to 700/300mm. I tryed to draw it manually via lines and then to make a block of it, and it's working ,but when I use the HIDE command I still can see trough it. Any ideas? Quote Link to comment Share on other sites More sharing options...
MSasu Posted January 16, 2013 Share Posted January 16, 2013 You should draw the sections at both ends with respect for their relative location and apply the LOFT command on them. Quote Link to comment Share on other sites More sharing options...
Rubbersnow Posted January 16, 2013 Author Share Posted January 16, 2013 it's exactly what I wanted to do. working perfect. thank you very much Quote Link to comment Share on other sites More sharing options...
MSasu Posted January 16, 2013 Share Posted January 16, 2013 You're entirely welcome! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.