Jump to content
mledingham

Torsion - applying as to change length of part!

Recommended Posts

mledingham

I'm struggling with a concept we are trying to run.

We have created a spring, cut from a cylindrical pipe and we wish to apply torsion so as to tighten it up, therefore reducing its diameter and increasing it's length BUT maintaining the same pitch.

The profile is a 1" wide rectangle and our aim is to ensure it maintains its pitch so that, in our application, we essentially wind it up to fit onto a smaller diameter and need to represent the two states.

Can this be done? I tried to figure it out using adaptive springs to give me the sizes I need but couldn't quite get it to work, so hopefully someone can shed some light on this for me!

 

I hope the image helps to show what I'm aiming to do.

Spring.jpg

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...