SirGouldy 10 Posted July 27, 2015 Hi fellow creators, im new to this forum and thought i could get some advice from you guys. I have been using inventor for a while now and have a basic understanding on how to use it However im not sure if the stuff that i am making is any good, what do you think... Quote Share this post Link to post Share on other sites
tzframpton 32 Posted July 27, 2015 Not sure why you'd use Inventor for architectural residential design. That was a little painful to watch when there's programs that exist specifically for architectural design that can create the same project in a fraction of the time, with tools meant for designing a building or house. The content aside, seems the modeling turned out well but I don't know enough about Inventor to know if you were performing commands accurately. The end result was good, however. Quote Share this post Link to post Share on other sites
rkent 18 Posted July 27, 2015 I have to agree with tz, not the right tool for the task. At the end of the day you have a mass model with no intelligence in terms of an architectural model. Do that in a BIM program like Revit and you have a whole lot of built-in information to pull BOM's, coordination with other disciplines, etc. And you can edit the Revit model much easier than Inventor when talking about A/E models. Fun video to watch however. Quote Share this post Link to post Share on other sites
Lazer 0 Posted August 16, 2015 Missed this one been in Egypt for 3 weeks. With you guys on this. Even Sketch up would have been a better tool to model this. Fun but painful to watch. Quote Share this post Link to post Share on other sites
