Jump to content

Applying bulking and shrinking factors to balance grading.


SMP

Recommended Posts

Good Afternoon CAD folk,

 

I am wondering if perhaps i am missing something somewhere in Civil3D's settings to input my clients bulking and shrinking factors so that when it blances my grading it just takes care of all that for me.

 

Currently i am using the volume analysis tab and using the cut factor and fill factor to math it out for me and then i just go into the grading volume tools and adjust up and down as needed?

 

Is there another place such as ambient settings or in the site properties that i might be missing that i can input these values?

 

Thanks!

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...