mfour1337 10 Posted May 1, 2018 if anyone has a free couple hours please see if you can draw the attached dwg in solidworks in 3d, i cant seem to figure out the barrier. its a tough one screw.pdf Quote Share this post Link to post Share on other sites
BIGAL 149 Posted May 2, 2018 I am charged out at work at $130/Hr for a couple of free hours. Asking for some one to draw something is asking how much are you prepared to pay. The majority here work for a living so sometimes there is not a free couple of hours. Advice on how to do it yourself I am sure will come free, I don't use Solidworks or would offer some Free advice. Quote Share this post Link to post Share on other sites
SLW210 58 Posted May 2, 2018 Maybe THIS will help get you started. Quote Share this post Link to post Share on other sites
mfour1337 10 Posted May 3, 2018 Maybe THIS will help get you started. Its tough because i can draw all types of screws in solid works its just when i have two leads with multiple depths i cant figure it out. guess ill keep trying until i can get it. Quote Share this post Link to post Share on other sites
