Jump to content

Fabric area counts fabric sheets at openings


Recommended Posts

When I place a fabric area, Revit just leaves all sheets at ('small') openings to fully count (i.e. the cut sheet mass is the same as a full sheet). When the openings get

bigger (10-15 m2) Revit starts to really cut the sheets.

Say we have 50 openings, then 500m2 of fabric sheets is counted (or even ordered!) too many.

Obviously we don't want that. Is that something that can be changed somewhere?



Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...