Jump to content
Engineer_learning

Corridor Subassembly Question

Recommended Posts

Engineer_learning

Hello,

 

I am looking for some help in modelling a corridor creating a forestry roadway down the side of a steep mountain. The subsurface is rock with a couple of meters of softer overburden.

 

I would like to have a subassembly that is able to show a cut in the top 2.0m of the target surface at 1:1 slope and then, if required to get down to my road grade cut the remaining slope much steeper 4:1.

 

I am used to working from my roadway elevation up towards my target surface but here I need to do the opposite and am not sure how to tackle it?

 

Thanks Very Much

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...