Jump to content

issue with cut/fill slopes


Recommended Posts



I have a 2:1 slope on each side of the assembly. If the slope can reach the eg surface in a positive direction it catches there even though it would work in a negative direction as it is configured in the assembly. If the slope cannot catch the eg in a positive directionslope.thumb.PNG.eff9eeb85fd50624dc9f640bc2f4d0d2.PNG it 'fills' properly. I have tried this with a linkslopetosurface and a daylight subassembly and get the same results. Any help or suggestions are appreciated.




Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...