Sengna Posted April 23, 2019 Posted April 23, 2019 (edited) i was trying to extruded cut at the red arrow on the right, i put in T1 value at 0.15 in and it gave me error as shown, i sketched the cut out section which was in close profile and no opening, i changed the value to smaller number but still get the error. What did i do wrong? (this part is the bulb for a flashlight) greatly appreciate any help. thank you. Edited April 25, 2019 by Sengna Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.