Jump to content
chubarka

small selection square jumps around

Recommended Posts

chubarka

Will one of  you Guru's here tell me why my small selection square will not land on a line for me to select, but rather jumps all around it.

I am trying to put a fillet between two lines forming a corner and the small selection square that comes up will not allow me to select

the lines, but lands on either side of the line. I am new to Autocad.

Thank you in advance,

Chubarka

Share this post


Link to post
Share on other sites
rkmcswain

It sounds like you have SNAP enabled.

By default, the F9 key will toggle SNAP on and off. Tap the F9 key and try again.

Edited by rkmcswain
add URL
  • Like 1

Share this post


Link to post
Share on other sites
chubarka

Thank you so much!

Share this post


Link to post
Share on other sites
Dadgad

BINGO! @rkmcswain nailed it!    :beer:

 

Having GRID turned on can also potentially lead to selection problems, dependent upon the scale of your Grid.     ;)

  • Like 1

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...