chubarka 10 Posted February 23 Will one of you Guru's here tell me why my small selection square will not land on a line for me to select, but rather jumps all around it. I am trying to put a fillet between two lines forming a corner and the small selection square that comes up will not allow me to select the lines, but lands on either side of the line. I am new to Autocad. Thank you in advance, Chubarka Quote Share this post Link to post Share on other sites
rkmcswain 88 Posted February 23 (edited) It sounds like you have SNAP enabled. By default, the F9 key will toggle SNAP on and off. Tap the F9 key and try again. Edited February 23 by rkmcswain add URL 1 Quote Share this post Link to post Share on other sites
chubarka 10 Posted February 24 Thank you so much! Quote Share this post Link to post Share on other sites
Dadgad 69 Posted February 24 BINGO! @rkmcswain nailed it! Having GRID turned on can also potentially lead to selection problems, dependent upon the scale of your Grid. 1 Quote Share this post Link to post Share on other sites