Jump to content

Close /open properties dialog

jan brauer

Recommended Posts

I have made a routine which - via sendcommand - corrects the Annotation setup of objects - works perfectly!!😀.


But the program slows down a lot if the properties dialog is displayed - the dialog box flashes for each object that is processed.

I would therefore like to turn off the properties dialog while the program is running - this can be done with a SENDCOMMAND "PROPERTIESCLOSE ",.

But I would - of course - like to show it again - if it was shown before the program started.


But I can't figure out if the dialog box is shown.


Some ideas on how to view the on properties dialog are shown.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...