jfg Posted April 26, 2009 Share Posted April 26, 2009 Hi, I'm using ACA 2008... I have a plan with columns and a walltype that has batting insulation. I added a subtractive intereference condition where the wall meets the column to try and clean it up. All the wall components get cleaned up except the insulation. The insulation is part of the wall style as a single line with line type batting. Any help would be appreciated. I attached the drawing in question in case it would help. Thanks JF 0903A-ENVE-NV01.dwg Quote Link to comment Share on other sites More sharing options...
jfg Posted April 26, 2009 Author Share Posted April 26, 2009 I think it would help if I uploaded the columns too...so here you go 0903S-COLS-NV01.dwg Quote Link to comment Share on other sites More sharing options...
Noahma Posted April 26, 2009 Share Posted April 26, 2009 is that the right column file? I cannot seem to get the xref to refresh when I update its path. Quote Link to comment Share on other sites More sharing options...
jfg Posted April 26, 2009 Author Share Posted April 26, 2009 Yes it is. Its for a course I'm taking and I have to admit I have nothing but problems with ACA. I'm looking forward to finishing the course and never using it again I think... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.