erin0karr Posted July 5, 2013 Share Posted July 5, 2013 I'm working with AutoCAD Architecture 2011 and working in the xref. I have my layer states set up, no problem. However, I have a layer that still shows up in all states even tho it is not saved in the layer states. If i click on it, it shows as off. It is a block, I have it on the ByLayer and the correct layer. I cannot figure this out.. thanks in advance. Quote Link to comment Share on other sites More sharing options...
erin0karr Posted July 5, 2013 Author Share Posted July 5, 2013 ahhh nevermind, the layer within the block was not correct! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.