Search the Community
Showing results for tags 'soldiworks'.
Found 1 result
I am coming up to the 3 year mark of working with Solidworks (in education not professionally!). I have an imported surface that I have made some modifications to for a hinge mechanism. It has come to my attention that I have made the surface 'too curved', I have spent hours trying to adjust the curves on the two sides - I only need the two sides curved around 25% less (doesn't need to be dimensionally perfect at all! just look right! If anyone could shed some light on how I would go about this... hopefully without re-doing the whole part again as I have several other pieces I need to attempt the procedure on also! See sample. If you would like to see the part, I can provide you with the upload link as it is too large to upload unfortunately